Community-sourced DIY repair guides for the 2021–2021 International RH, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Air leak in spring brake chamber — parking brake may engage (21V-226 / Navistar 21502) Factory-documented(12.4L International A26 diesel (370–475 hp), Cummins X15 diesel (400–605 hp))
Dealer-only recall repair — free at any International dealer. Owner-side value: the RH slice of this campaign is tiny — only 2 RH trucks (TSE Brakes lot F5Z, built March-July 2020) — but if yours is one of them, the failure mode is the parking brake engaging on its own from an air leak.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer-only recall — spring brake chamber inspection and replacement; no owner torque specs apply.
Tips
615 trucks (2021 LT and RH): the spring inside the spring brake chamber may allow the pressure plate to shift and wear a hole through the diaphragm. A hole in the diaphragm causes an air leak — and an air leak in the spring-brake circuit can make the parking brake ENGAGE unexpectedly, a crash risk at speed.
The population detail matters for RH owners: the Part 573 report breaks it down as 613 LT trucks and only 2 RH trucks, built with spring brake chambers from TSE Brakes lot F5Z (RH builds March 26 through July 6, 2020). This is an honest edge case — a 2021 RH is very unlikely to be in this population, but the VIN check is free and takes a minute.
Remedy: dealers inspect and, as necessary, replace the spring brake chambers, free of charge. Owner notification letters were mailed May 28, 2021; Navistar's number is 21502. Quarterly reports show 573 of 615 remedied by Q3 2022.
Paired with the sibling campaign 21V-227 (Bendix SC-3 check valve, same April 2021 announcement, also covering 2021 RH) — see the companion note. A 2021 RH deserves a VIN check against both.
Dealer-only recall repair — free at any International dealer. Owner-side value: this is a compliance recall, not a wear item — the check valve itself gets replaced, so don't pay for a valve job on a 2021 RH without checking the VIN first.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer-only recall — SC-3 check valve replacement; no owner torque specs apply.
Tips
845 trucks (2021 HV, LT, MV, RH) equipped with Bendix pressure switches: a retainer was not properly seated in the SC-3 single check valve and may not provide source air isolation when pressure is applied. Without source air isolation the trucks fail to comply with FMVSS 121, 'Air Brake Systems' — the federal air-brake standard.
Announced April 1, 2021 alongside the sibling 21V-226 (spring brake chamber) campaign — the two recalls hit the same announcement cycle and both cover 2021 RH trucks. This is the follow-up candidate the LT run #329 flagged; for the RH it is a primary campaign with confirmed RH population.
Remedy: dealers replace the SC-3 check valves, free of charge. Navistar's number is 21503; customer service 1-800-448-7825. NHTSA's number is 21V-227.
A 2021 RH should be VIN-checked against BOTH 21V-226 and 21V-227 — same announcement, different defects, different remedies. The companion note documents 21V-226.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2021–2021 International RH yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.