Community-sourced DIY repair guides for the 2018–2020 International LT, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
A26 wrist-pin bushing may fail — wave 1 (20V-255 / Navistar 20504) Factory-documented(12.4L International A26 diesel (370–475 hp))
Dealer-only recall repair — free at any International dealer. Owner-side value: this is wave ONE of the A26 wrist-pin saga — trucks repaired under this campaign had to return for waves two (21V-281) and three (22V-691). A 2018-2020 A26 LT needs all applicable waves closed, not just this one.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer-only recall — engine detection-system calibration and connecting rod repair; no owner torque specs apply.
Tips
5,277 trucks (2018-2020 LT, 2019-2020 RH) with International A26 engines built February 10, 2018 through June 2019: the connecting rod's small-end (wrist pin) bushing can crack or shed chunks of bushing material over time, leading to connecting rod failure and an engine shutdown with minimal warning. The population later grew to 5,192 in quarterly reports; initial press cited ~4,500.
The warning signs are the ones an owner-operator can actually hear and feel: a knocking noise, the engine warning light, or a rough idle. The Part 573 report is explicit that while the driver can usually pull to the shoulder, a stalled Class 8 truck in or near the roadway is the crash risk.
Wave one launched before the remedy existed — the May 2020 filing said the fix was 'still under development.' What arrived: a ~45-minute engine calibration (detection system) that warns the driver before rod failure, plus repair of engines found with defective rods. The recall began July 8, 2020 (Navistar 20504).
The saga matters more than the single campaign: this was the FIRST of three wrist-pin/connecting-rod recalls (20V-255 → 21V-281 → 22V-691). Navistar's own later filings state that trucks repaired under 20V-255 had to come back for the revised remedy. Check all three on any 2018-2020 A26 LT — the companion notes document waves two and three.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 2 complaints for the 2018–2020 International LT. 2019 was the worst year (2 complaints). Most-reported areas: engine, power train, service brakes.
18V199000 (29/03/2018) — FUEL SYSTEM, DIESEL Navistar, Inc. (Navistar) is recalling certain 2018-2019 International LT trucks. When the hood is in the closed position, the fender splash panel may rub on the inlet fuel line fitting to the fuel/water separator, causing abrasion damage to the fitting…
22V546000 (28/07/2022) — ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES Navistar, Inc. (Navistar) is recalling certain 2018-2021 International LoneStar and 2016-2021 International LT vehicles. The cables that connect the batteries to the vehicle frame may become excessively hot, and in some cases, cause battery post separation.
19V122000 (26/02/2019) — ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE Navistar, Inc. (Navistar) is recalling certain 2016-2020 International LT and 2017-2018 Prostar 73-inch sleeper cab models equipped with feature code 07BKP or 07BKR (exhaust system with horizontal after treatment device and horizontal tailpipe mounted on right side). In the affected…
25V817000 (25/11/2025) — ELECTRICAL SYSTEM:SOFTWARE International Motors, LLC (International) is recalling certain 2016 7600, 2016-2023 Lonestar, 2018 8600, 2018-2023 LT, 2021-2026 MV, 2022-2023 RH, 2023-2026 HX, and 2025-2026 HV vehicles. Electrical noise and low signal to the power line carrier may cause the ECU to…
21V281000 (22/04/2021) — ENGINE Navistar, Inc. (Navistar) is recalling certain 2019-2021 International LT and RH trucks. The wrist pin may crack and cause connecting rod failure.
18V826000 (21/11/2018) — POWER TRAIN:CLUTCH ASSEMBLY Navistar, Inc. (Navistar) is recalling certain 2019 International HV, MV, 2018-2019 HX, LT, RH, LoneStar, ProStar, WorkStar, and 2018 TranStar automated manual transmission vehicles, equipped with certain Eaton ECA heavy-duty truck clutches. An internal component in the clutch assembly may…
18 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2018–2020 International LT yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.