Community-sourced DIY repair guides for the 2019–2023 International CV515, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Brake pressure switch assembly leak → electrical short → fire risk (23V-282 / Navistar 23511) Factory-documented(6.6L Duramax V8 diesel (350 hp / 700 lb-ft))
Dealer-only recall repair — free at any International dealer. The owner-side value: a used CV515 can still show this campaign open — check the VIN at nhtsa.gov/recalls before buying, and confirm all linked brake campaigns are closed, because later recalls re-repaired trucks already fixed under earlier ones (the same three-act brake saga as the Chevrolet Silverado MD twin).
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer-only recall — brake pressure switch assembly replacement and wire-harness/fuse inspection; no owner torque specs apply.
Tips
The International twin of GM's 23V-266: Navistar recalled 9,170 CV trucks for the same brake pressure switch assembly defect — brake fluid leaks past the diaphragm seal into the switch's electrical components, shorts the switch and fuse, and can start an underhood fire while driving OR parked with the engine off. Park-outside advisory; Navistar's number 23511, customer service 1-800-448-7825.
Year-range honesty: NHTSA labels this “2017-2023 International CV” (the build span starts with September 2017 pilot builds; Transport Canada lists 2017-2024 CV). The CV Series is a 2019-model-year product — this note keys to the real 2019-2023 model years so it routes correctly.
Same Kodiak Controls-supplied hardware as the Chevrolet Silverado MD twin, built on the same Springfield, Ohio line. The defect, the park-outside order, and the remedy (replace the brake pressure switch assembly, plus wire harness or fuse if contaminated) mirror GM's campaign exactly — the only difference is the name on the dealer sign.
Completion is weak: Navistar's quarterly report showed only 4,413 of the 9,170 remedied by Q1 2024 — fewer than half. A used CV515 has real odds of showing this campaign still open; owner letters went out June 16, 2023.
Not the end of it: the June 2025 follow-up (25V-414, Navistar/International 25507) replaced the brake pressure switch/fuse harness on trucks including ones already fixed under 23V-282, and the November 2025 recall (25V-763 / 25521) re-repaired 2019-2020s whose remedy harness lacked protective material. A used CV515 needs all three closed, not just this one.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2019–2023 International CV515 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.