Community-sourced DIY repair guides for the 2019–2021 Infiniti QX50, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Fuel/oil smell in a closed garage: rocker cover + PCV separator TSB fix Owner-verified(2.0L KR20DDET VC-Turbo)
Driveway-friendly DIY: rocker/valve cover R&R plus the PCV separator is basic hand-tools work on the KR20DDET (the TSB points to the ESM's KR20DDET rocker-cover removal procedure). No special tools named in the bulletin.
Typical difficulty: Easy — based on 11 code guides for the pcv repair area (an area-level estimate, not this exact job).
Torque specs
Rocker cover fasteners: verify — Not published in the TSB; use the ESM KR20DDET rocker-cover procedure and a torque wrench - plastic covers crack when over-tightened.
Tips
The signature symptom: a strong gasoline or hot-oil smell in the garage after parking, with NO visible fuel, oil, or EVAP leak anywhere under the car. Multiple owners on InfinitiQX50.org report exactly this on 2019+ cars.
The early-2022 Infiniti TSB (NHTSA MC-10202232-0001) covers 2019-2021 QX50s and says to replace the rocker (valve) cover assembly AND the PCV separator/oil separator with the updated parts, and to eliminate PCV hose 2 entirely - it is no longer required with the new parts.
The updated rocker cover and PCV separator contain the fuel vapors/blow-by that were escaping; owners report the smell gone after the fix.
The same problem has been reported on 2022 QX55s built before August 2021 (per owner-roundup reporting), even though the TSB lists only the QX50 - worth checking with a dealer if your early QX55 smells.
If you DIY it, use the updated-spec cover and separator (not just a gasket) - a gasket alone does not fix the vapor path this TSB addresses.
Roaring cooling fan + A/C stops cooling: fan assembly TSB (updated Denso part) Owner-verified(2.0L KR20DDET VC-Turbo)
Mechanically DIY (fan assembly R&R is unbolt-and-swap), but read the caveat: the TSB says the IPDM E/R must be configured if it is replaced, which needs dealer-level tooling. Check the Denso part number on your current fan label first - if it is already the updated part, this TSB does not apply.
Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).
Tips
The signature symptom: the engine cooling fan suddenly runs at full speed and roars like a jet engine (owners describe it as audible from inside the car), and at the same time the A/C stops blowing cold. One 2019 owner had it in the shop five times for this.
The September-2022 Infiniti TSB covers 2019-2020 QX50s of all build dates, 2021 QX50s built on or before February 15, 2022, and 2022 QX55s built on or before February 15, 2022.
The fix is an updated cooling-fan assembly (check the Denso part number on the label of your current fan against the TSB's table - updated part = this TSB does not apply to you), plus IPDM E/R replacement/configuration if applicable.
Honest caveat for DIYers: the TSB notes the IPDM E/R will need to be configured if replaced - that step is dealer tooling. If only the fan assembly needs swapping, it is a mechanical R&R.
If your car is still under warranty, this is a free dealer repair; owners report dealers doing it under warranty once the TSB is referenced.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 33 complaints for the 2019–2021 Infiniti QX50. 2020 was the worst year (33 complaints). Most-reported areas: engine, forward collision avoidance, power train.
25V437000 (27/06/2025) — ENGINE AND ENGINE COOLING:ENGINE:HARD PARTS INTERNAL/MECHANICAL Nissan North America, Inc. (Nissan) is recalling certain 2021-2024 Rogue, 2019-2020 Altima, 2019-2022 Infiniti QX50, and 2022 Infiniti QX55 vehicles equipped with 3-cylinder 1.5L or 4-cylinder 2.0L variable compression turbo (VC-Turbo) engines. The engine bearings may have manufacturing defects that…
21V025000 (26/01/2021) — TIRES Nissan North America, Inc. (INFINITI) is recalling certain 2020 INFINITI QX50 vehicles. The text of the Tire and Loading Information placard, including the tire size and loading capacity, may be illegible. As such, these vehicles fail to comply with the…
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2019–2021 Infiniti QX50 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.