Community-sourced DIY repair guides for the 2021–2022 Hyundai Santa Fe, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
This is a dealer recall, not a driveway job. Your move is the VIN check: NHTSA.gov/recalls or Hyundai's recall portal with your 17-digit VIN, before you spend a dollar on diagnosis.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Recall remedy: verify — TCU software update and, where needed, transmission replacement — dealer-only procedure. No owner torque specs involved.
Tips
Hyundai recall 236 (NHTSA 22V-746) covers 32,833 Santa Fe units with the 2.5L turbo + 8-speed wet dual-clutch: the transmission's electric high-pressure oil pump can develop an internal fault from a supplier soldering defect, setting a DTC and forcing failsafe mode.
Know the failure signature so you are not caught off guard: warning lights first, then roughly 20–30 seconds of limited mobility, after which the TCU disengages the clutches completely and the vehicle stops. Hyundai reported 229 incidents; no crashes or injuries were confirmed, but losing propulsion in traffic is the safety case.
The free dealer remedy: TCU software update for every affected vehicle, plus transmission replacement where the pump has already failed. Owner notification letters went out December 5, 2022 — if you bought yours used, check the VIN regardless of what the seller says.
Distinct from the Tucson note covering the older 2016–2018 dry-DCT shudder: this is the 8-speed wet-clutch unit in the 2021–2022 2.5T only. Do not let anyone sell you a fluid service or a software 'TCU relearn' for a failsafe-mode stall — the recall path is the documented fix.
Dealer recall. 15,752 vehicles — 2021–2022 Santa Fe and Sonata with the 2.5L turbo. Check the VIN at NHTSA.gov/recalls before touching a wrench.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Torque specs
Recall remedy: verify — High-pressure fuel connection inspection/tightening or pipe replacement — dealer-only fuel-system work. No owner torque specs involved.
Tips
Hyundai recall 207 (NHTSA 21V-524): fuel can leak at the pipe connection between the high-pressure fuel pump and the fuel rail on 2.5L turbo Santa Fe models. A fuel leak next to hot engine components is a fire risk.
Telltale: a raw fuel smell in the engine bay or visible seep at the pump-to-rail connection. If you smell fuel, park it and call — do not keep driving to 'see if it gets worse.'
The free dealer remedy: inspect the connection and either tighten it or replace the fuel pipe. Owner notification letters went out September 3, 2021. An earlier May 2021 wave (21V-308) covered 2021 Santa Fe units; the July 2021 wave expanded to 2021–2022 — check both if your VIN is a 2021.
Do not pay for an HPFP 'reseal' out of pocket on an affected VIN — the connection fix is the documented remedy and it is free.
Rearview camera recall 24V879000 Factory-documented(1.6L Turbo Hybrid (Gamma II))
Dealer repair, free under the recall: technicians replace the rearview camera assembly.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
Recall camera replacement: verify — Dealer-performed recall — no owner torque involved. Confirm any fastener values against Hyundai service information.
Tips
NHTSA recall 24V879000 (Hyundai campaign 271, announced December 2024) covers certain 2021-2022 Santa Fe, 2021-2022 Santa Fe Hybrid, 2022 Santa Fe Plug-In Hybrid, 2021-2022 Elantra, 2021-2022 Elantra Hybrid, and 2022 Elantra N vehicles — 226,118 vehicles in total.
The defect: the rearview cameras may have been built with insufficient soldering on their printed circuit boards, so the camera image can fail to display when you shift into reverse. A missing rearview image violates FMVSS 111 (Rear Visibility), so it had to be recalled.
Dealers replace the faulty rearview camera assembly with a new one free of charge; owner notification letters were mailed in January 2025. If your backup camera intermittently goes blank on a 2021-2022 Santa Fe Hybrid, check whether recall 271 was performed before paying for a camera replacement.
Call Hyundai at 855-371-9460 (reference recall 271) or check your VIN on NHTSA's recall site.
Seat belt pretensioner recall 22V816000 Factory-documented(1.6L Turbo Hybrid (Gamma II))
Dealer repair, free under the recall: technicians install anti-separation protection caps on the front seat belt pretensioners.
Typical time: “The fix: dealers install anti-separation protection caps on the front seat belt pretensioners (about 0.7 hours labor), free of charge.” — as written in the note. First-timers often take twice this.
Torque specs
Recall pretensioner cap installation: verify — Dealer-performed recall — no owner torque involved. Confirm any fastener values against Hyundai service information.
Tips
NHTSA recall 22V816000 (Hyundai campaign 238/011G, announced October 2022) covers certain 2021-2022 Santa Fe Hybrid (TM HEV, built 12/18/2020 to 07/26/2022) and 2022-2023 Santa Fe Plug-In Hybrid vehicles — 14,928 vehicles in total, plus 2023 Genesis G80 Electric models under the same campaign.
The defect: the front driver- and passenger-side seat belt pretensioners may deploy abnormally in a crash, with the micro gas generator separating from the pretensioner pipe and potentially projecting metal fragments into the cabin. This is an expansion of the earlier pretensioner recalls 22V-354 and 22V-458.
The fix: dealers install anti-separation protection caps on the front seat belt pretensioners (about 0.7 hours labor), free of charge. Owner notification letters went out in December 2022, and a dealer stop-sale was issued for unsold affected vehicles.
Hyundai is not aware of any abnormal pretensioner deployments on these vehicles globally, but the caps still need to be fitted — check your VIN for open recall 238/011G.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2021–2022 Hyundai Santa Fe yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.