Community-sourced DIY repair guides for the 2022–2023 Hyundai Kona, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Kona N high-pressure fuel pump recall (24V-528) Owner-verified(2.0L T-GDI (Kona N))
Check your VIN for Hyundai recall 262 / NHTSA 24V-528 — the ECM software revision is free, and if the malfunction light is already on the high-pressure fuel pump replacement is free too. There was a dealer stop-sale on unsold affected cars.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
The high-pressure fuel pump's fuel control valve wears and lets excess fuel into the pump, so the engine runs rich — tells are a check-engine light, rough idle, misfire, and power loss especially at low speeds (in some cases limp mode above 60 mph). Covers 2022–2023 Kona N built 10/05/2021–04/25/2023, alongside Veloster N, Elantra N, and Genesis G70.
The dealer remedy: engine ECM software revision for every affected car, plus a new high-pressure fuel pump where the malfunction light is on — all free, with reimbursement for out-of-pocket repairs already done. Hyundai confirmed 2,460 incident reports; no crashes, fires, or injuries.
Distinct from the 8-speed DCT oil-pump recall (22V-746) — different component, different campaign. Do not let a dealer sell you a fuel-system cleaning for this symptom; the documented path is the recall.
Kona N is rare, so owner-thread confirmation is thinner than on the other notes here — but the remedy rests on Hyundai's own dealer best-practice document and the NHTSA filing, which is stated openly.
Kona N P1326 knock-sensor water intrusion (TSB 24-EM-010H) Factory-documented(2.0L Theta II T-GDI (Kona N))
Dealer-performed TSB, but the DIY value is real: recognizing the water-trigger pattern keeps you from paying for an engine tear-down you do not need.
Typical difficulty: Moderate — based on 841 code guides for the sensors repair area (an area-level estimate, not this exact job).
Torque specs
Knock sensor bolt: 21 N·m (16 lb-ft) — TSB 24-EM-010H family published spec; intake manifold does not need removal.
Tips
Learn the trigger pattern: P1326 sets AFTER a car wash or heavy rain, the CEL comes on and the car enters limp-home mode, but there is no abnormal engine noise. That combination is the TSB's exact applicability test — the bulletin only applies when the code follows water exposure and the engine sounds normal.
Scope is explicit: TSB 24-EM-010H (Dec 2024) covers ALL 2022–2023 Kona N (OS N). The fix: replace the knock sensor (39250-2G700FFF) and repair the connector wiring with the wiring kit (terminals, solder-seal joints, resin heat-shrink, harness re-tape).
The critical 'don't': if the engine is actually knocking, this bulletin does NOT apply — water intrusion is a false-positive pattern, and a real knock needs mechanical diagnosis, not a sensor swap. The bulletin is 1.7 hr of warranty labor.
The Kona N's published knock-sensor bolt torque is 21 N·m (16 lb-ft) per the HMA TSB family — keep that figure for any knock-sensor work on this car.
Kona N HPFP warranty extension Z04 (TSB 25-FL-002H) Factory-documented(2.0L Theta II T-GDI (Kona N))
Ask the dealer for the Z04 warranty extension (TSB 25-FL-002H) by name if your Kona N's pump acts up after the recall window — coverage is 15 years/150,000 miles and transfers to later owners.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Torque specs
High-pressure fuel pump: verify — Dealer-only replacement procedure under the extension; no owner torque specs involved.
Tips
Second layer of free coverage stacks on the HPFP defect: beyond recall 24V528000, warranty extension Z04 (TSB 25-FL-002H, Feb 2025) covers the high-pressure fuel pump itself to 15 years or 150,000 miles from original retail delivery, valid for original AND subsequent owners.
Scope is explicit: 2022–2023 Kona N (OS N) built 10/05/2021–04/25/2023, plus Veloster N and Elantra N. The extension's service kit for the Kona N is 35399-2G333QQH (ordered only when the car sets DTC P0088).
Symptom ladder for the extension: fuel control valve plunger wear lets excess fuel into the pump, the mixture runs rich, and you get DTC P0088 with loss of power at low speeds. If a dealer quotes an out-of-pocket pump replacement on a 2022–2023 Kona N with P0088, quote Z04 first.
This extension pairs with the existing recall note for the Kona N — the recall gets you the ECM software revision; Z04 keeps the pump covered for 15 years after.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2022–2023 Hyundai Kona yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.