Community-sourced DIY repair guides for the 2022–2022 Hyundai Kona, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Kona N T-GDI injector misfire P0300-P0304 (TSB 24-FL-006H) Factory-documented(2.0L Theta II T-GDI (Kona N))
Dealer-performed TSB, but the DIY value is recognizing the pattern: misfire codes on an early Kona N point at injectors, not plugs and coils.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Torque specs
High-pressure fuel pipe flare nuts: verify — Dealer tool 09314-3Q100 socket used for tightening both flare nuts; dealer-performed repair.
Tips
The tell: P0300, P0301, P0302, P0303, or P0304 on a 2.0T Kona N. TSB 24-FL-006H (Oct 2024) says the cause is the injectors leaking internally because the internal filter breaks apart — not worn plugs or bad coils.
Scope is explicit: 2022MY Kona N (OS N) built 10/05/2021–06/16/2022, alongside the 2022 Elantra N and 2021–2022 Veloster N. If your Kona N falls in that window with misfire codes, quote the TSB number instead of paying for a coil-pack guessing game.
The documented fix replaces all four injectors with kit 35399-2G033QQH (injectors 35310-2GHB0 plus high-pressure pipe and intake/throttle gaskets), with the special flare-nut socket for the high-pressure fuel pipe. Do not let a shop sell you a single injector — the bulletin prescribes the full set.
Don't confuse this with the HPFP recall (24V-528): that one is about rich-running from the pump's fuel control valve. Both affect the same Kona N population, so check for both. The misfire TSB is P030x codes; the pump recall is limp-mode/P0088.
Kona N 8-speed DCT fail-safe recall (22V746000) Factory-documented(2.0L Theta II T-GDI (Kona N))
Check your VIN for Hyundai recall 236 / NHTSA 22V746000 — the TCU software revision is free, and a transmission replacement is free too if the inspection finds damage.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
The defect: the 8-speed wet DCT's high-pressure electric oil pump can fail internally (poorly soldered circuit-board component), triggering codes and forcing the car into fail-safe — about 20–30 seconds of limited driving, then the clutches fully disengage and the car is immobilized.
Scope is explicit: recall 22V746000 (Hyundai campaign 236) includes the 2022 Hyundai Kona N built Aug 2020–May 2022, alongside Veloster N, Elantra N, Santa Cruz, Sonata, and Santa Fe. The 2022 Kona N is the only Kona N year in the population.
The documented remedy: dealer updates the TCU software for proper fail-safe driving capability, and replaces the whole transmission where inspection shows damage. Stop-sale was placed on affected unsold cars; 53,142 Hyundai vehicles recalled in the US.
Distinct from the HPFP recall (24V-528) — different component, different campaign. Warning signs are multiple transmission warning lights and a fail-safe message, not engine misfire.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2022–2022 Hyundai Kona yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.