Community-sourced DIY repair guides for the 2011–2013 Hyundai Elantra, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Brake pedal stopper pad (brake lights stuck on) Owner-verified(1.8L Nu MPI I4, 2.0L Nu MPI I4)
Kneel at the driver footwell and look up at the brake pedal arm — the stopper pad sits between the pedal arm and the stop lamp switch plunger. If it is crumbled, cracked, or missing, you have found it. No tools needed for the diagnosis.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
Stop lamp switch: verify — Torque specs not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Symptom signature: all brake lights stay on even with the car off, the traction control warning light stays lit, and the shifter can move out of Park without touching the brake — the car thinks the pedal is pressed because the deteriorated pad lets the switch plunger stay extended.
Hyundai recall 146 (NHTSA 16V-574) covers 64,500 2013 Elantras built December 1, 2012 through April 30, 2013 — dealers replace the stopper pad with an improved part free. Check your VIN against the recall before buying anything.
Outside the recall build dates, the same pad deterioration happens with age on other MD Elantras — the pad itself is a cheap part and a driveway swap. Do not let a shop sell you a full stop lamp switch first; the pad is the known failure point.
If the brake lights stay on overnight they will drain the battery — if you cannot get to the dealer immediately, a temporary measure owners use is disconnecting the battery or pulling the stop-lamp fuse until the repair.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 675 complaints for the 2011–2013 Hyundai Elantra. 2012 was the worst year (675 complaints). Most-reported areas: engine, electrical system, air bags.
15V871000 (23/12/2015) — ELECTRONIC STABILITY CONTROL (ESC) Hyundai Motor America (Hyundai) is recalling certain model year 2011-2012 Elantra vehicles manufactured October 29, 2010, to October 25, 2011. Due to an electronic stability control (ESC) sensor malfunction, the brakes for one or more wheels may be applied unexpectedly…
23V651000 (22/09/2023) — SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE Hyundai Motor America (Hyundai) is recalling certain 2011-2015 Elantra, Genesis Coupe, Sonata Hybrid, 2012-2015 Accent, Azera, Veloster, 2013-2015 Elantra Coupe, Santa Fe, 2014-2015 Equus, 2010-2012 Veracruz, 2010-2013 Tucson, 2015 Tucson Fuel Cell, and 2013 Santa Fe Sport vehicles. The Anti-Lock…
20V393000 (02/07/2020) — EQUIPMENT:ELECTRICAL Hyundai Motor America (Hyundai) is recalling certain 2011-2012 Hyundai Elantra and Sonata Hybrid, 2012 Accent and Veloster vehicles. The 12V accessory socket outlet may have been over-tightened during installation, possibly disabling the thermal fuse and allowing the outlet to overheat…
13V115000 (01/04/2013) — AIR BAGS:SIDE/WINDOW Hyundai Motor Company is recalling certain model year 2011-2013 Elantra vehicles manufactured from November 12, 2010, through March 5, 2013. A support bracket attached to the headliner may become displaced during a side curtain airbag deployment.
4 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2011–2013 Hyundai Elantra yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.