Community-sourced DIY repair guides for the 2017–2024 Honda Ridgeline, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Check your VIN for Honda recalls 6RW (22V-867, 2017–2019) and YI7 (24V-321, 2020–2024) — the dealer replaces the tailgate camera harness free. If you already paid for a camera-harness repair, ask about reimbursement.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
Tailgate camera harness: verify — Dealer-only recall replacement. No owner torque specs involved.
Tips
Repeatedly opening and closing the tailgate fatigues the rearview-camera wiring harness until the camera image dies in reverse. On 2017–2019 trucks (recall 22V-867, Honda 6RW, 117,445 vehicles) the defect was a protective corrugated tube that was too short into its guide plus a zip tie that was not tight enough — the wires wore, broke, and killed the camera. Honda logged 3,437 warranty claims and no injuries.
The two recalls are easy to confuse: 22V-867 covers 2017–2019 with the short-tubing/loose-zip-tie defect; 24V-321 (Honda YI7, 187,290 vehicles) covers 2020–2024, where the harness material itself was susceptible to breakage from repeated tailgate cycling. The 2020–2024 remedy is a new-supplier harness with better bend durability. Check your VIN for the right one.
Honest caveat: NHTSA opened a recall query (RQ24011) and then an engineering analysis (EA25003) on whether the 22V-867 replacement harnesses could fail the same way long-term. The analysis closed in September 2026 with no new recall — testing did not support the durability concern — but it means owners should still complete any open campaign and get persistent camera failures inspected even after the recall repair.
Do not pay for a camera or head-unit replacement for this symptom on a covered truck — the harness is the documented fix, and Honda reimburses owners who paid out of pocket before the recall.
Rear cab water leak — unsealed body seams behind the bed Owner-verified(3.5L J35Y6 V6 (2017–2024))
If the rear carpet is damp, lift it — the sound-deadener liner does not soak through, so the top can feel dry while the floor pan is wet. Push the dealer for a full seam diagnosis before the 3-year/36,000-mile warranty expires, and get Honda Corporate involved early if the dealer stops at one spot.
Torque specs
Body seam reseal: verify — Body-shop repair. No owner torque specs involved.
Tips
Water gets into the cab from body panel seams behind the bed that were not properly sealed at the factory — one of the most-reported 2nd-gen Ridgeline problems, with a 57-page owner poll thread. Water flows out of the bed and into the seams (worse when the truck sits nose-down), ending up under the rear carpet where you cannot see it without lifting the carpet.
There are usually multiple leak points, not one: the rear window seal and the high seams where the bedside support structure meets the cab — the high ones require pulling the bed apart and removing the rear fenders to reach, which is why some owners needed two or three dealer visits.
The documented fix is a dealer/body-shop reseal of every seam, found by pressurizing the cabin and spraying soapy water on the seams. Owners who got it fully fixed report Honda Corporate and field techs eventually authorizing the deep repair; press for carpet replacement too, since trapped moisture means mold.
Honest caveat: this is a dealer/body-shop job, not a driveway repair — the value here is knowing the pattern before you pay for carpet, electronics, or rust that the leak caused. Lock the claim in with Honda Corporate before the 3/36 warranty expires; several owners report dealers will not go deep enough on Honda's standard reimbursement unless pushed.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 229 complaints for the 2017–2024 Honda Ridgeline. 2020 was the worst year (169 complaints). Most-reported areas: electrical system, engine, unknown or other.
21V932000 (29/11/2021) — STRUCTURE:BODY:HOOD Honda (American Honda Motor Co.) is recalling certain 2019 Passport, 2016-2019 Pilot, and 2017-2020 Ridgeline vehicles. The hood latch striker may become damaged and separate from the hood, which can result in the hood opening while driving.
23V458000 (29/06/2023) — SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER Honda (American Honda Motor Co.) is recalling certain 2020-2021 Civic, 2020-2023 Ridgeline, 2021-2023 Passport, 2021-2022 Pilot, and 2020 Acura MDX vehicles. The tie rod fastener that connects the brake booster and the brake master cylinder may have been improperly assembled…
20E068000 (17/09/2020) — EQUIPMENT Honda (American Honda Motor Co.) is recalling all Honda Genuine Accessory Tonneau Covers, part number 08Z07-T6Z-100F, sold for installation on 2017-2020 Ridgeline trucks. If the tonneau cover is not properly secured in the open or closed position, wind resistance may…
23V174000 (16/03/2023) — VISIBILITY:REARVIEW MIRRORS/DEVICES:EXTERIOR Honda (American Honda Motor Co) is recalling certain 2020-2021 Pilot and Ridgeline, and 2020-2022 Passport and Odyssey vehicles. The heating pads behind both side-view mirrors may not be bonded properly, allowing the mirror glass to detach. As such, these vehicles…
9 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2017–2024 Honda Ridgeline yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.