Community-sourced DIY repair guides for the 2017–2019 Honda Ridgeline, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Check your VIN for Honda recall Q3V (19V-053) — dealers inspect the pump, replace it if needed, and fit a protective cover, all free. Recall work began March 2019.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Car-wash detergents containing sulfuric acid can drain from the bed down onto the fuel pump's feed port on 2017–2019 Ridgelines (recall 19V-053, Honda Q3V, 106,683 trucks). If the acid is not fully rinsed off, it cracks the port, and a cracked feed port leaks pressurized fuel — a fire risk.
This is a different failure from the Honda-wide Denso low-pressure fuel pump recall (that one is covered under the Accord fuel-pump note). The Q3V defect is Ridgeline-specific: the bed drains right onto the pump area, so the acid path is a packaging problem unique to this truck.
The tell is a fuel smell, especially after washes. The dealer inspects the pump, replaces it where cracked, and installs a protective cover over the feed port on every covered truck — even ones whose pumps pass inspection.
Owners on the forums note the access panel on top of the tank makes pump access easier than on trucks where the tank must be dropped, but the recall repair itself is still a free dealer job — do not pay for it.
Scan for DTC P0741 first. If it is stored on a 2017–2019 Ridgeline 6-speed, the torque converter replacement is covered free under warranty extension TSB 23-078 (8 years / 150,000 miles) — confirm VIN eligibility with the dealer.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Torque converter: verify — Dealer-only replacement under the extension. No owner torque specs involved.
Tips
This is a different failure from the well-known 6-speed judder. Some 2017–2019 Ridgeline (and 2017–2018 Pilot) torque converters were built with lockup pistons that can crack; pressure bleeds through the crack, the lockup clutch loses holding force, and the transmission sets DTC P0741 (torque converter clutch circuit performance or stuck off). The symptom is lost or slipping lockup, not the classic 20–60 mph shudder.
Honda extended the torque converter warranty to 8 years or 150,000 miles under TSB 23-078, and the corrective action is a free torque converter replacement — but only once P0741 is confirmed stored. Get the code read before authorizing anything.
Do not confuse this with the judder path: the Pilot torque-converter-judder note covers TSB 17-014/17-015/17-025/17-026, where the fix is a software update plus fluid service and the TSB explicitly says the converter is not the cause. Judder without P0741 goes down the software-and-fluid road (owners report three drain-and-fills with Honda DW-1 fixing it); P0741 goes down the free-converter road.
Owner reports on the forums show dealers sometimes needed the HDS snapshot confirming the shudder/judder source before acting — if your truck has the symptom but no P0741 yet, document it and keep the fluid fresh in the meantime.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2017–2019 Honda Ridgeline yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.