Community-sourced DIY repair guides for the 2020–2022 GMC Sierra HD, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Free at any GM dealer under N242454440. Check your VIN at nhtsa.gov/recalls; owner notification letters went out starting December 2024.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Recall remedy: verify — Software reflash at the dealer; the update does not replace the valve body, it adds wear detection.
Tips
GM Safety Recall N242454440 covers 2020-2022 Sierra HD (and Silverado HD) diesel trucks: the 10-speed's transmission control valve wears at an accelerated rate, gradually losing pressure. Shifting gets harsher over time, and at a certain wear point the valve can fail during a downshift from eighth gear, momentarily locking the rear wheels.
This is the 10L1000, the GM-built 10-speed co-developed with Ford (not the older Allison-built 6-speed). The stock transmission control module software could not detect the pressure loss, which is why GM issued a stop-sale and recalled about 462,000 trucks and SUVs in late 2024.
The dealer remedy is a transmission control module software update, not a hardware swap: the new software monitors valve performance and can detect excessive wear roughly 10,000 miles before a lockup condition, limiting the transmission to fifth gear until the next key cycle and flagging a 'reduced propulsion' message.
The recall got messy afterward: GM later found some 2020 trucks got the wrong software version that may not detect valve failure properly, triggering a smaller follow-up recall. If you had the first update done, confirm with the dealer that the current, correct software is installed.
This is a free dealer repair. Check your VIN at nhtsa.gov/recalls to confirm your truck is covered and that the remedy was actually completed, especially if you bought the truck used. Do not ignore harsh shifting on these trucks; it is the wear signature this recall is about.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2020–2022 GMC Sierra HD yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.