Community-sourced DIY repair guides for the 2001–2014 GMC 2500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
6.0L fuel pump — long crank / crank-no-start diagnosis and module replacement Owner-verified(6.0L Vortec V8 (LQ4/LQ9/LY6/L96))
Full driveway job — half a day. Drop the tank (or lift the bed) with as little fuel in it as possible; a floor jack under the tank makes lowering it controlled. Clean the tank top before opening it so no dirt falls in.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Tips
The 6.0L fuel-pump fingerprint: extended cranking before it catches (especially after sitting — the pump's check valve bleeds rail pressure down), progressing to crank-but-no-fire with no codes. Before condemning the pump, do the key-on test: you should hear the pump run for about 2 seconds at key-on, then it should run again only while cranking. Prime-but-no-run-while-cranking points at the relay or the ECM not seeing the engine turn (crank sensor), not the pump itself.
Check the fuel pump relay and its socket first — corroded or heat-discolored relay contacts are a cheap fix that mimics a dead pump. And remember the interplay: with no crankshaft position signal the ECM will not energize the pump relay during cranking and you will have no spark either, so a no-fuel-pressure + no-spark combination means test the crank sensor before buying a pump.
When the pump is genuinely dead, the job is a tank drop: support the tank on a jack, disconnect filler neck, EVAP and fuel lines plus both electrical connectors, loosen the two tank straps (15mm), lower it, clean the tank top thoroughly, twist the lock ring off, and swap the module — seating the float arm carefully and using the new o-ring supplied with the module. Do it on a near-empty tank; a full 2500HD tank is brutally heavy.
After installation, cycle the key a few times to prime before cranking, then check for leaks at every connection you touched and verify fuel pressure holds at the rail. If the truck still long-cranks after a new pump, suspect the fuel pressure regulator or a leaking injector bleeding the rail down overnight.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2001–2014 GMC 2500 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.