2024–2026 GMC Sierra EV

Community-sourced DIY repair guides for the 2024–2026 GMC Sierra EV, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

Slow DC fast charging (PIP6123, stuck at 400V) Factory-documented (all)

If DC fast charging is slow, rule out the easy causes first: check the 12V battery state of charge (below ~40% can cap you at 400V), try a different high-power station, and make sure the battery is preconditioned. If it is still stuck around 140 kW on a 350 kW station, reference PIP6123 at the dealer.

Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).

Tips

Sources: GM bulletin PIP6123 (Sierra EV listed, cause)

No owner reports yet — fixed this yourself? tell us how

High-voltage system fault pattern (isolation fault, no-charge) Owner-verified (all)

If the truck throws a high-voltage warning, note exactly what the dash says and whether charging and regen both degrade — that combination points at the HV system rather than the charger. Then it is a dealer matter; early-production trucks have needed extended stays, so nail down loaner coverage when you book.

Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).

Tips

Sources: owner reports (isolation fault, early VINs, loaner issues) · owner report (36k mi, charge + regen loss, module replacement) · owner report (repeated SHV warnings, buyback)

No owner reports yet — fixed this yourself? tell us how

Truck goes dead despite charge (12V triage) Community-reported (all)

If the truck goes completely dead, try the owner soft reset first: hold the end-call button on the steering wheel for about 20 seconds, then walk away with the key for 5–10 minutes. If that fails, the 12V disconnect (frunk, left side, negative cable off for two minutes) is the next step — the owner's manual shows the access procedure.

Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).

Typical time: “If the truck goes completely dead, try the owner soft reset first: hold the end-call button on the steering wheel for about 20 seconds, then walk away with the key for 5–10 minutes.” — as written in the note. First-timers often take twice this.

Tips

Sources: owner incident + community fixes (soft reset, 12V disconnect)

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

What owners report

NHTSA recorded 13 complaints for the 2024–2026 GMC Sierra EV. 2025 was the worst year (7 complaints). Most-reported areas: visibility/wiper, fuel/propulsion system, service brakes.

Counts are NHTSA complaints filed for these model years, via the NHTSA API. See data for all Sierra EV years →

Recalls

7 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.

Factory service bulletins

We don't have factory bulletin data for the 2024–2026 GMC Sierra EV yet.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.