Community-sourced DIY repair guides for the 2021–2025 Genesis GV80, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer TSB work under warranty — but the symptom pattern is what you need to describe so the tech pulls the right bulletin instead of guessing.
Typical difficulty: Moderate — based on 60 code guides for the steering repair area (an area-level estimate, not this exact job).
Torque specs
Steering components: verify — Dealer TSB work — no owner torquing involved.
Tips
Two separate Genesis bulletins cover steering-wheel noise on 2021–2025 GV80s (2.5T and 3.5T), and the symptom tells them apart. A rubbing or dragging noise while rotating the wheel points at a misaligned clock spring — the TSB calls for inspecting and, if needed, replacing the multifunction switch. Airbag operation is not affected.
A rubbing-type noise on turns with a different character is covered by TSB 23-ST-004G: inspect the steering shaft dust cover and replace it if it's the noise source.
Both are warranty jobs — name the symptom precisely at the service desk ('rubbing/dragging when rotating the wheel') so the advisor pulls the steering bulletins instead of chasing alignment or tires.
Neither fix is a real DIY: the clock-spring job involves the airbag and steering electronics, and both procedures need the car on a lift with trim removed.
Dealer campaign work — but knowing the failure signature gets you the fix instead of a wet carpet and a mold bill.
Torque specs
Drain hose plugs: verify — Dealer campaign/TSB work — no owner torquing involved.
Tips
Limited coverage campaign L08G plus TSB 24-BD-008G-1 cover 2021–2025 GV80s (built 7/27/2020–8/12/2024): the sunroof drain hose plugs clog with debris, so water backs up into the cabin — or you hear water gurgling from the sunroof while driving in the rain.
The dealer procedure replaces the front drain hose plugs and cuts/modifies the rear ones so they can't clog the same way. The campaign version (2021–2022 builds) is performed on any affected car within the 5-year/60,000-mile new-vehicle warranty whenever it's in the shop.
The giveaway is wet carpet or headliner staining after rain with no obvious seal failure — that's drains, not glass. Don't let it sit: standing water under carpet breeds mold and corrodes connectors.
Owners of early builds should ask the dealer to check L08G status by VIN at any service visit; the later TSB revision extended the same repair to 2025 models.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 17 complaints for the 2021–2025 Genesis GV80. 2024 was the worst year (17 complaints). Most-reported areas: engine, electrical system, unknown or other.
25V105000 (20/02/2025) — ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL Hyundai Motor America (Hyundai) is recalling certain Genesis 2023-2024 G80, GV80, 2025 GV70 and 2023-2025 GV70 "Electrified" vehicles. Due to a software error, the instrument panel display may fail. As such, these vehicles fail to comply with the requirements of…
26V229000 (10/04/2026) — FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS Hyundai Motor America (Genesis) is recalling certain Genesis 2022-2026 GV70, 2023-2025 G90, 2021-2025 G80, and GV80 vehicles. Fuel may leak at the pipe connection between the fuel pipe and fuel rail.
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2021–2025 Genesis GV80 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.