Community-sourced DIY repair guides for the 2008–2016 Chrysler Town & Country, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Through the sliding door's inner trim: the door panel and window regulator come out to reach the lock actuator buried in the door. Owners report 5-6 hours the first time; the job is tedious rather than technically hard.
Typical time: “Owners report 5-6 hours the first time; the job is tedious rather than technically hard.” — as written in the note. First-timers often take twice this.
Torque specs
Door lock actuator fasteners: verify — No torque-critical fasteners confirmed from owner sources — confirm against factory service info before torquing.
Tips
The failure pattern: the sliding door stops responding to the power lock buttons and fob while the manual latch still works — or the lock grinds, loops, or dies entirely. One owner reports it can also drain the battery if the actuator sticks in a loop.
The part is cheap (~$50 aftermarket on eBay; Mopar units listed around $22-72) while shops quote $650-1,300, because the labor is a full door teardown — not because the part is hard.
Owner-verified gotcha: the window regulator must come out with the panel, and it is easy to accidentally unwind the window cable during removal — keep the glass secured before you start.
One owner did it in a little over an hour with experience and says it is the same procedure on the Routan, T&C, and Grand Caravan; a first-timer's mechanic took 5-6 hours. Plan a full afternoon.
Do not let the door be shut and locked when you start — the job is markedly harder with a locked-shut door, per multiple owner reports.
Valve body is accessed through the transmission pan from below — the TCC solenoid swaps without pulling the transmission. Pan bolts come off with the fluid drained; the solenoid pack sits on the valve body.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Typical time: “A DIY video documents the exact procedure and a clean road test 20 days later.” — as written in the note. First-timers often take twice this.
Torque specs
62TE transmission pan bolts: verify — A DIY video states 108 in-lbs (9 ft-lbs) for pan bolts — confirm against factory service info for the 62TE before torquing.
Tips
Learn the symptom pattern: the van randomly stalls at stoplights or when coming to a stop, only when warm, with zero codes — because the converter clutch stays locked instead of unlocking. Owners describe it as feeling like stopping a manual car in gear without pressing the clutch.
The in-car fix: replace the TCC solenoid (Mopar 5169313AA) plus a fluid and filter service — done through the pan, no transmission removal. A DIY video documents the exact procedure and a clean road test 20 days later.
Do this BEFORE authorizing a $4,000 shop rebuild — multiple owners were quoted full replacements for what turned out to be the solenoid.
Use ATF+4 only (Mopar or Valvoline ATF+4), and check the pan magnet for debris while you are in there: clutch material in the pan means the converter itself is shedding and the solenoid alone will not save it.
Related but different: a light-throttle shudder at 45-55 mph that stops the instant you tap the brake is the converter clutch slipping, not the solenoid — chryslerminivan.net owners confirm the brake-tap test distinguishes them.
No cold air — rear A/C evaporator leak Owner-verified(3.3L V6, 3.8L V6, 4.0L V6, 3.6L Pentastar V6)
The rear evaporator sits in the rear HVAC housing behind the interior panels on the rear side. Refrigerant must be recovered first (a shop job), then panels come out to expose the unit. Plan on a 30-minute vacuum pull before recharging.
Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).
Torque specs
Evaporator/AC line fasteners: verify — Torque specs not confirmed from owner sources — confirm against factory service info before torquing AC fittings.
Tips
The signature: no cold air front OR rear on a dual-zone van. Multiple TrueDelta owner records show the rear evaporator corroding and leaking — one was replaced at Chrysler's cost on a 2011, another on a 2010 with the extension line.
Diagnose before condemning the compressor: if the system holds some charge but the evaporator shows UV-dye or oily residue at the rear unit, the compressor is innocent — one tech warns against replacing the compressor when the evaporator is the leak.
This is a driveway-feasible R&R once the refrigerant is recovered by a shop: interior panels come out, the old unit swaps, then the system needs a proper 30-minute vacuum before recharging.
While you are in there, inspect the rear AC extension lines and seals — owners report the lines corrode alongside the evaporator, and replacing them together avoids a repeat evacuation.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
NHTSA recorded 1,160 complaints for the 2008–2016 Chrysler Town & Country. 2012 was the worst year (634 complaints). Most-reported areas: electrical system, power train, engine.
11V487000 (29/09/2011) — ENGINE AND ENGINE COOLING CHRYSLER IS RECALLING CERTAIN MODEL YEAR 2012 CHRYSLER VEHICLES, INCLUDING 200 AND TOWN AND COUNTRY MODELS, DODGE VEHICLES, INCLUDING CHARGER, DURANGO, GRAND CARAVAN AND JOURNEY MODELS AND JEEP GRAND CHEROKEE VEHICLES MANUFACTURED FROM AUGUST 31, 2011, THROUGH SEPTEMBER 13, 2011…
16V047000 (29/01/2016) — AIR BAGS:FRONTAL FCA US LLC (Chrysler) is recalling certain model year 2009 Dodge Journey vehicles manufactured December 31, 2007, to August 31, 2008, 2008-2009 Dodge Grand Caravan and Chrysler Town and Country vehicles manufactured June 18, 2007, to August 31, 2008. In…
16V044000 (28/01/2016) — VISIBILITY:WINDSHIELD FCA US LLC (Chrysler) is recalling certain model year 2015-2016 Chrysler Town and Country, and 2014-2015 Dodge Grand Caravan vehicles manufactured August 16, 2014, to December 5, 2015. The windshield on the affected vehicles may have been installed using expired…
14V373000 (26/06/2014) — ELECTRICAL SYSTEM:IGNITION:SWITCH This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from…
15V595000 (24/09/2015) — LATCHES/LOCKS/LINKAGES:HOOD:LATCH Chrysler Group LLC (Chrysler) is recalling certain model year 2016 Chrysler Town and Country and Dodge Grand Caravan vehicles manufactured August 19, 2015 to August 27, 2015. In the affected vehicles, the bolts that attach the hood striker may loosen…
16V461000 (24/06/2016) — POWER TRAIN:AUTOMATIC TRANSMISSION Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Chrysler Town & Country, Dodge Grand Caravan vehicles manufactured July 31, 2015, to April 18, 2016, 2016 Dodge Journey vehicles manufactured August 17, 2015, to January 29, 2016, and 2016…
17 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2008–2016 Chrysler Town & Country yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.