2017–2024 Chrysler Pacifica

Community-sourced DIY repair guides for the 2017–2024 Chrysler Pacifica, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

Battery replacement Owner-verified (3.6L Pentastar V6)

The Pacifica has an ESS (engine start/stop) dual-battery setup under the hood: the main battery plus a smaller AUX14 auxiliary battery for start/stop, both tucked below the airbox — remove the airbox (a few bolts) to get proper working room at the battery tray. Replacement itself is basic 10mm/13mm work, but the critical step is resetting the start/stop warning light afterward: you must disconnect BOTH batteries (main and aux), then reconnect, to clear the ESS warning. The aux battery's negative cable connects to the main battery's negative cable end via a power control relay.

Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: owner forum · owner forum · tech article on ESS dual-battery service

P0562 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Front brake pads & rotors Owner-verified (3.6L Pentastar V6)

Front pads and rotors are a standard two-bolt-caliper job: wheel off, caliper bolts out (hang the caliper — never let it dangle by the hose), bracket off, and the rotor slides off the hub. Clean the hub face with a wire brush so the new rotor seats flat, wipe the new rotor's braking surface with brake cleaner, and compress the caliper piston with the old pad in place. The Pacifica-specific trap is the REAR brakes: the electronic parking brake must be put in brake service mode from the Uconnect interface before you push the rear pistons back, or you'll have a bad day with the EPB actuator.

Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: owner forum · YouTube DIY

C0035 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Thermostat replacement Community-reported (3.6L Pentastar V6)

On the 3.6L Pentastar the thermostat is sold as a complete assembly with its plastic housing — it sits at the engine-side end of the upper radiator hose, reached by removing the engine cover and air cleaner, draining coolant below the housing level, and undoing the upper hose. The housing is held by a few bolts; because the intake manifold region is already apart for the 100k spark-plug service, experienced owners bundle the thermostat assembly, the coolant crossover pipe, and the oil filter housing into one teardown. The assembly includes a bleeder screw — use it when refilling so air pockets don't leave the gauge reading normal while the heads run hot.

Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: owner forum

P0128 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Spark plugs & ignition coils Owner-verified (3.6L Pentastar V6)

On the transverse 3.6L Pentastar the three rear (firewall-side) plugs are buried under the intake plenum, so this is a plenum-removal job: engine cover and airbox come off, upper intake manifold bolts come out, and several vacuum and sensor connectors plus the throttle-body connector must be unplugged. Stuff rags in the open intake runners the moment the plenum is off — dropping a bolt or tool into the intake is the classic driveway disaster on this job. The front three are under their coil packs and take minutes once the plenum is back on.

Typical difficulty: Easy — based on 64 code guides for the ignition repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: YouTube DIY · YouTube DIY · owner forum

P0300 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Oil filter housing replacement Owner-verified (3.6L Pentastar V6)

The plastic oil filter/cooler housing sits down in the intake valley (the 'V' of the engine), so the upper intake manifold must come off to reach it — a 2-hour job that first-timers report taking 5-6 hours. Access requires disconnecting coolant lines attached to the housing and unbolting it from the block; the kit ships with new upper and lower intake-manifold gaskets, which you must replace since the manifold is removed. On 2017–2024 housings, the upper oil-pressure sensor has an updated design: swap the original sensor from the old housing onto the new one before installing.

Typical difficulty: Moderate — based on 5 code guides for the oil repair area (an area-level estimate, not this exact job).

Typical time: “The plastic oil filter/cooler housing sits down in the intake valley (the 'V' of the engine), so the upper intake manifold must come off to reach it — a 2-hour job that first-timers report taking 5-6 hours.” — as written in the note. First-timers often take twice this.

Torque specs

Tips

Sources: YouTube DIY · press write-up with owner detail · owner forum

P0520 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Transmission fluid service Owner-verified (3.6L Pentastar V6)

The gas Pacifica uses the ZF 9HP48 9-speed (Chrysler 948TE), a 'sealed for life' unit with no owner dipstick — but a drain-and-fill is very doable. There's an unlabeled drain plug next to and below the axle-shaft opening; the fill plug is accessed from above. There is no serviceable filter (it's internal, requiring transmission removal), so this is a drain-and-fill-only job: owners report about 3.5 quarts drains per cycle and do serial drain-and-fills (driving ~20 miles between cycles) to refresh most of the fluid. Correct level is temperature-dependent, so a scan tool that reads transmission fluid temperature plus a marked dipstick tool is needed to verify the final level.

Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: owner forum · YouTube DIY · expert Q&A

P0700 on this Chrysler Pacifica — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

Codes on this Pacifica

C0035
2017–2024 Chrysler Pacifica
Front brake pads & rotors
P0128
2017–2024 Chrysler Pacifica
Thermostat replacement
P0300
2017–2024 Chrysler Pacifica
Spark plugs & ignition coils
P0301
2017–2024 Chrysler Pacifica
Spark plugs & ignition coils
P0302
2017–2024 Chrysler Pacifica
Spark plugs & ignition coils
P0303
2017–2024 Chrysler Pacifica
Spark plugs & ignition coils
P0520
2017–2024 Chrysler Pacifica
Oil filter housing replacement
P0521
2017–2024 Chrysler Pacifica
Oil filter housing replacement
P0522
2017–2024 Chrysler Pacifica
Oil filter housing replacement
P0562
2017–2024 Chrysler Pacifica
Battery replacement
P0700
2017–2024 Chrysler Pacifica
Transmission fluid service
P0741
2017–2024 Chrysler Pacifica
Transmission fluid service

What owners report

NHTSA recorded 213 complaints for the 2017–2024 Chrysler Pacifica. 2020 was the worst year (170 complaints). Most-reported areas: electrical system, engine, power train.

Counts are NHTSA complaints filed for these model years, via the NHTSA API. See data for all Pacifica years →

Recalls

15 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.

Factory service bulletins

NHTSA has published 1,574 manufacturer communications (service bulletins, dealer notices) covering the 2017–2024 Chrysler Pacifica.

Most cited systems: Electrical System (636), Equipment (453), Power Train (188), Structure (168), Back Over Prevention (119).

Latest bulletins:

NHTSA also opened 6 defect investigations covering these years.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.