Community-sourced DIY repair guides for the 2015–2017 Chrysler 200, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Software flash done by a Chrysler, Jeep, Dodge, or RAM dealer — free under the recall. Nothing for a DIYer to install; the owner-side work is the safety procedure below.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
Recall repair: verify — No torque-critical fasteners — the remedy is a dealer software flash, not a hardware repair.
Tips
If the cruise control is accelerating (for example, climbing a hill to hold speed) at the same time a short circuit occurs in a specific electrical network, the cruise may refuse to disengage — neither the brake tap nor the cruise button will cancel it on an unpatched car.
Until your car is flashed, FCA's standing guidance is to not use cruise control at all. The dealer remedy is a free powertrain-control-module software flash under FCA campaign U49 (NHTSA 18V-332); roughly 4.8 million FCA vehicles share this recall, including the 2015-2017 Chrysler 200.
If it ever happens to you while driving: press the brakes firmly and steadily (the brakes are designed to overpower the engine), shift the transmission to neutral, and once stopped, put it in Park — that sequence finally cancels the cruise.
Check your VIN at nhtsa.gov or through FCA (1-800-853-1403) to confirm whether this recall is still open on your car before a long highway trip where you would normally rely on cruise.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 344 complaints for the 2015–2017 Chrysler 200. 2016 was the worst year (344 complaints). Most-reported areas: engine, electrical system, air bags.
18V332000 (17/05/2018) — ELECTRICAL SYSTEM:WIRING Chrysler (FCA US LLC) is recalling certain 2014-2018 Dodge Journey, Charger and Durango, RAM 2500, 3500, 3500 Cab Chassis (more than 10,000lb), 4500 Cab Chassis and 5500 Cab Chassis, Jeep Cherokee and Grand Cherokee and Chrysler 300, 2014-2019 RAM 1500…
16V589000 (10/08/2016) — STEERING Chrysler (FCA US LLC) is recalling certain model year 2016 Chrysler 200 vehicles manufactured May 24, 2016, to May 25, 2016. Multiple chassis fastener joints may not have been tightened to the proper torque specification.
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2015–2017 Chrysler 200 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.