2007–2013 Chevrolet Silverado 1500

Community-sourced DIY repair guides for the 2007–2013 Chevrolet Silverado 1500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

AFM lifter collapse / tick Owner-verified (5.3L V8 (LC9/LMG/LY5))

The AFM lifters live in the block under the cylinder heads — replacing them means both heads come off, which is why this job snowballs. The special collapsing lifters are on cylinders 1, 4, 6, and 7 only; the other eight are standard lifters.

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: silveradosierra.com: 2008 AFM lifter problem on 5.3 (DOD delete consensus) · silveradosierra.com: 08 5.3L LC9 failed lifter (GM TSB diagnostic procedure) · silveradosierra.com: 2011 5.3 AFM lifter tick (GM correction: replace all 16 lifters)

P0300 on this Chevrolet Silverado 1500 — full diagnosis guide →

No owner reports yet — fixed this yourself? tell us how

5.3L oil consumption (AFM) Owner-verified (5.3L V8 (LC9/LMG/LY5))

The updated valve cover is on the driver side and swaps with basic hand tools; the AFM oil shield requires dropping the oil pan, which is the bigger half of the job. Check the PCV baffle inside the old cover while it is off — misaligned baffles were a factory defect on some covers.

Typical difficulty: Moderate — based on 5 code guides for the oil repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: gm-trucks.com: GM TSB 10-06-01-008M (AFM shield + updated valve cover) · tahoeyukonforum: Fed up with 5.3 oil consumption (valve cover + Range device results) · 247sports: 2007-2011 GM truck oil consumption fix (valve cover + AFM baffle) · GM TSB 10-06-01-008H text: AFM shield P/N 12639759, 28 Nm

No owner reports yet — fixed this yourself? tell us how

Intermediate steering shaft clunk Owner-verified (5.3L V8 (LC9/LMG/LY5))

GMT900 issue with a GM bulletin. Bulletin (dated Aug 9, 2012): pop, click, or clunk noise at low speeds over bumps, felt through the steering column to the steering wheel, on 2007–2013 Silverado/Avalanche/Tahoe/Sierra/Yukon/Escalade (excluding hybrids). Root cause documented by owners and techs: the intermediate steering shaft's splines lose their grease and bind, then release with a clunk. Owner-verified DIY fix (5-minute version): remove the pinch bolt that holds the upper and lower shafts together (under the hood near the brake booster), pump the inner shaft in and out fully several times to redistribute the grease on the splines, and reinstall. Critical safety warning repeated across every thread: do NOT rotate the steering wheel while the shaft is disconnected or you will damage the SIR (airbag) clock spring. The permanent fix is the updated intermediate shaft; one 2007 Silverado owner had the sliding knuckle joint replaced for $274 and reported the truck felt new.

Typical difficulty: Moderate — based on 60 code guides for the steering repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: JustAnswer (GM master tech): 2007–2013 Silverado pop/click/clunk bulletin — lower steering shaft as the source · TractorByNet: 2007 Chevy Silverado bumping noise in steering (sliding knuckle joint replacement, $274) · SilveradoSS.com: Fix the steering shaft clunk in 5 minutes or less (pinch-bolt grease redistribution)

No owner reports yet — fixed this yourself? tell us how

Third brake light water leak Owner-verified (5.3L V8 (LC9/LMG/LY5))

Age-related GMT900 leak: the foam gasket around the third (high-mount) brake light hardens and cracks, letting rainwater run down into the cab. Telltale is staining across the rear of the headliner after rain — a 2012 Silverado owner found the same stain pattern on every GMT900 truck he inspected and traced it to the cracked 3rd-brake-light foam gasket. Owner-verified fix: remove the two screws, pull the housing, scrape off the old gasket, clean the surface, and install the upgraded gasket (single-sided gasket versions are the owner-recommended upgrade). Takes minutes with a T20 Torx; do not overtighten on reinstall or the housing cracks.

Tips

Sources: JetBoaters.net: Roof leak? 2012 Silverado (owners converge on 3rd brake light seal; TSB updated seal noted) · YouTube (AnthonyJ350): 2007–2013 Chevy Silverado & GMC Sierra Third / 3rd Brake Light seal upgrade (water leak)

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

Codes on this Silverado 1500

P0300
2007–2013 Chevrolet Silverado 1500
AFM lifter collapse / tick
P0301
2007–2013 Chevrolet Silverado 1500
AFM lifter collapse / tick
P0304
2007–2013 Chevrolet Silverado 1500
AFM lifter collapse / tick
P0306
2007–2013 Chevrolet Silverado 1500
AFM lifter collapse / tick
P0307
2007–2013 Chevrolet Silverado 1500
AFM lifter collapse / tick

What owners report

No NHTSA complaint data in our records for the 2007–2013 Chevrolet Silverado 1500 specifically. See NHTSA data for all Silverado 1500 years →

Factory service bulletins

We don't have factory bulletin data for the 2007–2013 Chevrolet Silverado 1500 yet.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.