Community-sourced DIY repair guides for the 2024–2025 Buick Envista, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer job — the 6T40 has to come out to replace the torque converter, so there is no driveway version of this repair. Your part as the owner is the diagnosis sequence: rule out the ANC speaker noise first, then make sure the dealer completes TSB 23-NA-194 before anyone approves a converter.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Torque converter / transmission fasteners: verify — Dealer-performed transmission-out repair — torque specs not confirmed from an owner source; confirm against factory service info.
Tips
Learn the signature: a shudder that feels like driving over rumble strips at 28-53 mph under light throttle. That speed-banded, load-dependent shudder is the torque-converter pattern — not a general transmission failure.
Rule out the ANC booming noise before touching the transmission. Manually hold the engine near 1,800 RPM and listen at the speakers: ANC noise comes through the speakers even with the radio off, at 1,500-2,000 RPM under steady load. That is a radio software fix, not a transmission repair.
GM's prescribed order matters: bulletin 24-NA-242 explicitly says TSB 23-NA-194 must be reviewed and completed first, because it addresses a similar shudder and is far more likely to resolve the concern. Only if the shudder survives 23-NA-194 does the bulletin authorize torque-converter replacement.
The converter replacement is covered under the factory powertrain warranty on these new vehicles — push back if a dealer jumps straight to quoting a converter or a full transmission.
If your shudder is a low booming or drumming instead of a rumble-strip shake, see the ANC path: an A11 radio software update, not transmission parts.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 55 complaints for the 2024–2025 Buick Envista. 2024 was the worst year (55 complaints). Most-reported areas: electrical system, unknown or other, engine.
26V539000 (20/08/2026) — BACK OVER PREVENTION: SENSING SYSTEM: CAMERA General Motors, LLC is recalling certain 2024-2025 Buick Envista, 2024-2026 Buick Encore GX, Chevrolet Trailblazer, and 2025 Chevrolet Trax vehicles. The rearview camera screen may display a distorted or blank image.
23V744000 (06/11/2023) — ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL General Motors, LLC (GM) is recalling certain 2024 Buick Encore GX, Envista, and Chevrolet Trax vehicles. The software in the Virtual Cockpit Unit Module (VCU) may cause the instrument panel display to intermittently go blank at vehicle startup or while…
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2024–2025 Buick Envista yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.