Community-sourced DIY repair guides for the 2020–2020 Buick Encore GX, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer-only recall work: the dealer inspects the camshaft cover for the blockage and replaces the cover if it is restricted. No owner teardown needed.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
Camshaft cover: verify — Dealer recall repair; no owner torque spec published in the sources — verify against factory service info if doing the work outside the recall.
Tips
Voluntary emission recall GM A202319910 targets 2020 Encore GX with the 1.2L LIH: the PCV passage inside the camshaft (cam) cover can be blocked from the factory, so crankcase pressure climbs until the engine runs rough — and the check-engine light comes on.
This is not a harmless light. A GM preliminary-information bulletin describes the failure chain: rising crankcase pressure balloons the rear main seal housing until the crankshaft reluctor makes contact with the crank sensor. That produces a crank-no-start or MIL with P0335/P0336.
If the reluctor has already cut through the rear main seal housing, metal contamination can force an engine replacement — so a 1.2L Encore GX that cranks but will not start, or throws crank-sensor codes, should go to the dealer promptly rather than sitting.
The dealer inspects the cam cover and replaces it if the passage is restricted, free under the recall. If your 2020 1.2L was never checked, ask the dealer to look up the field action on your VIN.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
NHTSA recorded 70 complaints for the 2020–2020 Buick Encore GX. 2020 was the worst year (70 complaints). Most-reported areas: service brakes, unknown or other, power train.
20V588000 (24/09/2020) — SERVICE BRAKES General Motors LLC (GM) is recalling certain 2020 Chevrolet Corvette and Cadillac CT4, CT5 and XT4, 2021 Chevrolet Trailblazer, and 2020-2021 Buick Encore GX vehicles. Sensor connection contamination in the electronic brake boost system may cause an interruption of communication…
21V440000 (10/06/2021) — EQUIPMENT:MECHANICAL:ACCESSORY SCISSOR/SCREW/BOTTLE JACK/LIFT:STAND General Motors, LLC. (GM) is recalling certain 2020-2022 Buick Encore GX and 2021-2022 Chevrolet Trailblazer vehicles. The emergency jack, if not positioned as directed in the vehicle owner's manual, can fracture while in use.
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2020–2020 Buick Encore GX yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.