Community-sourced DIY repair guides for the 2016–2018 BMW X1, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Engine mount replacement is an under-car job — the right (passenger-side) mount is the one the TSB names. The related transmission-mount creak and control-arm knock are diagnosed from underneath with a pry bar on a lift.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
Engine mount fasteners: verify — Torque specs not confirmed from a forum source — confirm against factory service info before torquing.
Tips
The signature symptom is a knock or clunk from the right front of the engine compartment, often when first moving off from rest or engaging Drive/Reverse. BMW service bulletin B22 02 17 names a damaged right-side engine mount as the cause.
Multiple F48 owners report the mount was the fix — one confirmed the dealer replaced it per the bulletin and the knock disappeared; another had it done in the car's first year. A full DIY video for the B46 F48 exists.
Two companion TSBs cover the rest of the F48 front-end noise family: B22 01 17 for a creaking noise when cornering (rubber transmission mount rubbing the aluminum housing) and a separate bulletin calling for both front control arms with a revised part on certain production dates (original arms defective from the factory).
If the car knocks over speed bumps specifically rather than on pull-away, look at the control-arm bushings first — several owners cured that version with revised wishbones; the engine mount is the pull-away/gear-engagement knock.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 159 complaints for the 2016–2018 BMW X1. 2016 was the worst year (159 complaints). Most-reported areas: unknown or other, power train, visibility/wiper.
15V887000 (30/12/2015) — STEERING:GEAR BOX (OTHER THAN RACK AND PINION) BMW of North America, LLC (BMW) is recalling one model year 2016 MINI Cooper Hardtop 2 Door vehicle manufactured November 24, 2015, and one BMW X1 Sports Activity Vehicle (SAV) manufactured October, 19 2015. The steering gearbox may have been…
16V747000 (17/10/2016) — SEAT BELTS:FRONT:RETRACTOR BMW of North America, LLC (BMW) is recalling certain model year 2016-2017 X1 sDrive28i, X1 xDrive28i, MINI Hardtop 4 Door Cooper, Mini Hardtop 4 Door Cooper S, MINI Cooper Clubman, and Cooper S Clubman, 2017 Rolls-Royce Ghost, and 2016 528i…
19V349000 (09/05/2019) — STRUCTURE:BODY:ROOF AND PILLARS BMW of North America, LLC (BMW) is recalling certain 2016-2019 X1 sDrive28i and X1 xDrive28i vehicles. In the event of a crash where the occupants head contacts the B-pillar, the pillar may not absorb an adequate amount of the impact…
3 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2016–2018 BMW X1 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.