Community-sourced DIY repair guides for the 2010–2016 Audi A5, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
3.0T supercharged: water pump, thermostat, and PCV Owner-verified(3.0L TFSI supercharged V6 (EA837))
Supercharger comes off for access: accessory belt and supercharger belt removed, intake manifold and fuel rails moved aside, front of the car put in service position. Full-day DIY for a first-timer; owners who have done it say the second time goes much faster.
Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).
Torque specs
Water pump / thermostat / PCV fasteners: verify — No torque spec confirmed from a forum source -- confirm against factory service info before torquing.
Tips
The factory water pump is plastic with a deliberate weep hole: a coolant stain or drip at the pump means the bearing seal is done and the pump is on borrowed time, not a hose you can tighten.
Replace the water pump, thermostat, and PCV valve as a set. The supercharger has to come off for any one of them, and owners repeatedly report fixing one only to be back in for the next within months. The PCV diaphragm fails around the same mileage and causes oil consumption on top of the coolant leak.
While the supercharger is off, inspect the two intercooler bricks inside it. A slow coolant loss with no external leak plus a misfire that survives new coils and plugs points at a brick leaking coolant into the intake -- the telltale is clean washed metal inside the intercooler where coolant has been steaming off.
Dealer quotes in owner threads run $1,800 to over $5,000 for this job; the parts are a few hundred dollars. Multiple owners did it in a home garage with standard tools plus the belt-routing knowledge from the DIY guides.
Refill with the VW-spec coolant for your VIN and bleed the system properly -- the supercharger has its own cooling circuit that traps air if rushed.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 29 complaints for the 2010–2016 Audi A5. 2012 was the worst year (22 complaints). Most-reported areas: air bags, engine, electrical system.
18V229000 (11/04/2018) — ENGINE AND ENGINE COOLING:COOLING SYSTEM Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2013-2017 Audi A5 Cabriolet, A5 Sedan and Audi Q5 vehicles, 2012-2015 Audi A6 vehicles and 2013-2016 Audi A4 Sedan and A4 allroad vehicles. These vehicles, equipped with 2.0l Turbo FSI engines…
17V622000 (05/10/2017) — ELECTRICAL SYSTEM:WIRING Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2013-2016 Audi A5 Coupe, A5 Cabriolet, A4 Sedan, A4 Allroad and Q5 vehicles. Contact corrosion within the electrical connector for the auxiliary heater may cause the heater wires to overheat or…
17V002000 (03/01/2017) — ENGINE AND ENGINE COOLING:COOLING SYSTEM Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2013-2017 Audi A5, A5 Cabriolet and Q5 vehicles, 2013-2016 Audi Allroad and Audi A4 vehicles and 2012-2015 Audi A6 vehicles. These vehicles, equipped with 2.0l Turbo FSI engines, have an electric…
3 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2010–2016 Audi A5 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.