Community-sourced DIY repair guides for the 2024–2024 Acura ZDX, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
EBCM software recall (ABS could cut braking under 25 mph) Factory-documented(all)
Over-the-air fix or a dealer visit: the remedy is a free Electronic Brake Control Module software update. If your ZDX is enrolled in OnStar with the terms accepted, the update can install itself at home in about five minutes (the car is inoperable during the install); otherwise a dealer flashes it with their diagnostic interface.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
EBCM software update: verify — Software-only recall, no fasteners touched.
Tips
The Electronic Brake Control Module software can misread wheel slip at low speeds, so the ABS keeps releasing brake pressure on dry, flat pavement. The result is weak or no braking with no warning to the driver.
The recall covers 4,174 all-wheel-drive 2024 ZDXs (A-Spec AWD and Type S) built between December 19, 2023 and August 1, 2024. Two-wheel-drive cars are not affected.
Acura issued a stop sale on August 15, 2024 alongside the recall (Honda number UJE, service bulletin 24-050). Owner letters went out around September 23-26, 2024.
The fix is free: an over-the-air software update delivered to the 11.3-inch touchscreen after shifting to Park (check Settings > Updates > History), or a dealer install for cars that can't take the OTA update. No parts and no special tools are involved.
Instrument cluster / rearview camera display recall (RCM software) Factory-documented(all)
Dealer visit: the remedy is a free Radio Control Module software update performed at an Acura dealer. Owner notification letters were mailed in April 2026.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
RCM software update: verify — Software-only recall, no fasteners touched.
Tips
Six separate software defects in the Radio Control Module can each trigger a processing error that stops the module from sending data to the displays. The instrument cluster can go blank while driving (no speedometer, no warning lights), and the infotainment screen can show no rearview camera image in reverse. Restarting the car sometimes brings the displays back.
The recall covers 19,573 Acura ZDX vehicles built between December 19, 2023 and January 22, 2025, plus 45,562 Honda Prologues, for a total of 65,135 vehicles. Honda estimates roughly 1 percent will actually show the defect; 148 warranty claims were on file when the recall was announced.
These vehicles fail FMVSS 101 (controls and displays), 111 (rear visibility), and 305 (electric-powered vehicles) when the displays fail.
Honda's numbers for this recall are TNL and XNK. Dealers update the Radio Control Module software free of charge; owner letters were mailed around April 20-22, 2026.
Dealer-only diagnosis and repair: the fix is a Battery Energy Control Module software update plus a manual reset procedure, done with Acura's diagnostic tools. But knowing the symptom pattern tells you what to ask for at the service desk.
Typical difficulty: Involved — based on 854 code guides for the battery repair area (an area-level estimate, not this exact job).
Typical time: “Warranty time is about 0.4 hour for the programming plus the resets.” — as written in the note. First-timers often take twice this.
The telltale pattern: the Malfunction Indicator Lamp comes on, or a 'Service High Voltage' message appears, and the 12-volt battery drains intermittently or constantly even though the big battery is fine. Scan codes P2C8A and/or P2C8B (plus U3577 through U3580 and U35AF) point at this bulletin; the bulletin only applies if all of the listed codes are set.
The root cause is an internal Battery Energy Control Module calibration anomaly, not a bad 12V battery. Replacing the 12V battery on its own will not fix it.
The published fix is a BECM software update followed by the manual reset procedure performed twice, then a 12V battery charge-and-test. Warranty time is about 0.4 hour for the programming plus the resets.
This is the ZDX version of the same BECM issue covered on the platform-sibling Honda Prologue (Honda bulletin 25-043). The Acura bulletin applies to all 2024 ZDX trims.
Dealer reflash: the fix is an A11 Radio Control Module software update using Acura's diagnostic interface. But the symptom list in the bulletin is useful for confirming your glitch is a known one before you go in.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
RCM software update: verify — Software-only TSB, no fasteners touched.
Tips
Service bulletin 25-033 (July 29, 2025) bundles the known A11 Radio Control Module software fixes for the 2024 ZDX. If your car shows any of these, the dealer reflash is the published fix.
Covered symptoms: switching to SiriusXM freezes the center screen on a 'Loading' message; the 'Brake' message fails to appear on the meter during a front collision warning; a duplicate 'Trunk open' message shows in the meter; the head-up display is distorted; DTC U0211 (lost communication with the memory seat module); and intermittent blanking of the instrument cluster and/or infotainment display while driving.
The bulletin first checks the current software version (0.2 hr inspection), then reprograms the module if needed (0.7 hr including inspection).
This TSB predates and is separate from the 26V112 recall, but both target the same module: get the recall done too if your car is in its population.
Dealer repair: the published fix ends with replacing the Air Suspension Control Module manifold (part 86587321), which means a lift, leak inspection, and an air-suspension inflator tool. This is a know-what-to-ask-for note, not a driveway job.
Typical difficulty: Moderate — based on 27 code guides for the suspension repair area (an area-level estimate, not this exact job).
Typical time: “Warranty time is 2.2 hours including inspection and DTC clear.” — as written in the note. First-timers often take twice this.
Torque specs
Air suspension control module manifold (86587321): verify — Dealer replacement per TSB; confirm torque against factory service info.
Tips
The symptom: a 'Service Leveling System' warning on the dash with DTC C1194 (air reservoir pressure below threshold) set against the K5 automatic level control module. Type S owners in the Consumer Reports survey report the air suspension control module failing outright and the warning light coming back repeatedly.
Per service bulletin 26-039 (January 15, 2026, revised February 18, 2026), the cause is internal contamination of the Air Suspension Control Module manifold, not a simple leak.
The published fix: inspect the air suspension system for leaks first; if no leaks are found, replace the Air Suspension Control Module manifold (part 86587321). Warranty time is 2.2 hours including inspection and DTC clear.
This bulletin applies to the 2024 ZDX Type S only, which is the trim with the air suspension.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
NHTSA recorded 56 complaints for the 2024–2024 Acura ZDX. 2024 was the worst year (56 complaints). Most-reported areas: forward collision avoidance, service brakes, unknown or other.
26V112000 (26/02/2026) — BACK OVER PREVENTION:SOFTWARE Honda (American Honda Motor Co.) is recalling certain 2024 Acura ZDX and Prologue vehicles. Due to a software error, the instrument panel display may fail. Additionally, a software error may cause the rearview camera to display a blank screen when…
25V018000 (16/01/2025) — ELECTRICAL SYSTEM:PROPULSION SYSTEM: CABLES Honda (American Honda Motor Co.) is recalling certain 2024 Acura ZDX vehicles. The front passenger stabilizer bar bracket bolts may become loose and detach from the frame, which can damage the high voltage cables or EV battery coolant lines.
24V614000 (15/08/2024) — SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE Acura (American Honda Motor Co.) is recalling certain 2024 Acura ZDX All-Wheel Drive vehicles. The anti-lock brake system (ABS) may activate unexpectedly and release brake pressure in the vehicle's service brake system.
26V306000 (14/05/2026) — BACK OVER PREVENTION: SENSING SYSTEM: CAMERA American Honda Motor Company (Honda) is recalling certain 2024-2025 Honda Prologue and 2024 Acura ZDX vehicles. The rearview camera screen may display a distorted or blank image.
25V234000 (10/04/2025) — SUSPENSION:FRONT:STABILIZER BAR Honda (American Honda Motor Co.) is recalling certain 2024 Acura ZDX vehicles. The passenger-side front stabilizer bar bracket bolts may have been improperly tightened, which can allow the bolts to loosen and separate from the vehicle frame. A detached stabilizer…
5 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2024–2024 Acura ZDX yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.